TRIVET NPI40
The trivet for the NPI40 is attached by two set screws on the inside of the hopper lid.
INSTALL VIEWING DOOR NPS40 AND NPI40
The main viewing door has been boxed separate from the heater, but MUST be installed before burning the heater.
1.Open both side panels, exposing the bushing on the left and the latches on the right.
Figure 33
2.Align the pins on the door to the bushing on the left side of the heater. Lower into place until both bushings touch.
(Insert
3. Engage the latch hooks into the door frame. Snap the rear handle hook to Illustrated) lock the latch closed.
25
Figure 32
LIGHTING HEATER MANUALLY
Your heater can be lit manually without using the automatic igniter by following the procedure below.
!WARNING
Heater may be hot.
Other than placing a handful of pellets in the burn pot for lighting manually, never feed pellets through the glass viewing door. An "OVERFIRE" condition could occur, if more pellets enter the firebox then what the feed tube can deliver. Pellets must only be burned within the burn pot.
1.Press the start switch
2.Turn feed dial to "Optimum"
3.Place a "handful" of pellets into the burn pot.
4.Cover with a small amount of approved
5.Light fi re starter with a match and close the viewing door.
PROPER PELLET LOADING
Before loading pellets into the hopper first transfer the pellets from it's original plastic bag to a metal bucket. NOTE: If the pellets are kept in the plastic bag, the bag may come in contact with the heater causing the bag to melt and the pellets to spill.
DO NOT load pellets into the hopper if they have been exposed to moisture. Moisture can cause pellets to swell and cause blockage in the feed system. Thoroughly dry pellets before placing into hopper.
