©
National Instruments Corporation I-1 DAQArb 5411 Use r Manual

Index

Numbers
+5V signal (table), 3-7
A
analog filter correction, 4-24to 4-25
analog output, 4-18to 4-21
analog output and SYNC out block
diagram, 4-18
output attenuation, 4-19 to4-20
output enable, 4-21
output impedance, 4-20
pre-attenuation offset, 4-21
specifications, A-1
SYNC output and duty cycle, 4-19
waveform, trigger, and marker timings
(figure), 4-19
ARB connector, 3-2
Arb mode, 4-3 to4-8
burst trigger mode, 4-15 to4-16
continuous trigger mode, 4-14
minimum buffer size and resolution, 4-5
single trigger mode, 4-12to 4-13
stepped trigger mode, 4-14to 4-15
VirtualBench-Arb (note), 4-2
waveform linking and looping, 4-5to 4-8
waveform memory, 4-4
waveform size and resolution, 4-4to 4-5
Arb operation
analog filter correction, 4-24to 4-25
analog output, 4-18to 4-21
analog output and SYNC out block
diagram, 4-18
output attenuation, 4-19to 4-20
output enable, 4-21
output impedance, 4-20
pre-attenuation offset, 4-21
SYNC output and duty cycle, 4-19
waveform, trigger, and marker timings
(figure), 4-19
Arb mode, 4-3to 4-8
minimum buffer size and
resolution, 4-5
waveform linking and looping,
4-5to 4-8
waveform memory, 4-4
waveform size and resolution,
4-4to 4-5
calibration, 4-28
DAQArb 5411 block diagram, 4-1
digital pattern generation, 4-25to 4-27
data path (figure), 4-26
timing (figure), 4-26
direct digital synthesis (DDS) mode,
4-8to 4-11
DDS building blocks (figure), 4-9
frequency hopping and sweeping, 4-11
frequency resolution and lookup
memory, 4-10to 4-11
marker output signal, 4-16to 4-18
generated marker positions
(table),4-17
markers as trigger outputs (figure), 4-17
overview, 4-1to 4-2