Chapter 2 Configuration and Installation
NI 7350 User Manual 2-4 ni.com
Hardware Installation
You can install the NI 7350 controller in any open compatible expansion
slot in the computer. Appendix A, Specifications, lists the maximum power
required for the NI 7350 controller.
The following instructions are for general installation. Refer to the
computer user manual or technical reference manual for specific
instructions and warnings.
Caution The NI 7350 controller is a sensitive electronic device shipped in an antistatic
bag. Open only at an approved workstation and observe precautions for handling
electrostatic-sensitive devices.
♦PXI-7350
1. Power off and unplug the chassis.
Caution To protect yourself and the chassis from electrical hazards, the computer should
remain unplugged until the installation is complete.
2. Choose an unused +3.3 V or +5V peripheral slot and remove the filler
panel.
3. Touch a metal part on the chassis to discharge any static electricity that
might be on your clothes or body. Static electricity can damage the
controller.
4. Insert the PXI controller into the chosen slot. Use the injector/ejector
handle to fully insert the device into place.
5. Screw the front panel of the PXI controller to the front panel mounting
rails of the chassis.
6. Visually verify the installation.
Caution Make sure you have correctly connected all safety devices before you power on
the motion system. Safety devices include inhibits, limit switches, and emergency shut
down circuits.
Caution Always power on the chassis containing the NI 7350 controller then initialize the
controller before you power on the rest of the motion system. Power off in the reverse order.
7. Plug in and power on the chassis.
8. Initialize the controller.