Index
NI VXIpc-882 User Manual I-4 ni.com
See also configuration
hard drive, 2-6
NI VXIpc-882 installed in a VXI chassis
(figure), 2-3
RAM, 2-4
removing NI VXIpc-882 from VXI
chassis, 2-3
installing an ExpressCard/34 module, 2-7
instrument drivers (NI resources), D-1
Integrated Peripherals menu, 3-15
inverting the CLK10 signal (figure), 3-12
K
KnowledgeBase, D-1
L
LabVIEW, 1-4
LEDs, front panel LEDs, 5-15
LPT cable, connecting to NI VXIpc-882, 6-6
M
main power fuse, replacing, 6-7
Main Setup menu, 3-14
manuals directory, 6-1
mating connector
GPIB (IEEE 488.2), 5-11
parallel port, 5-7
Measurement & Automation Explorer
(MAX), 3-20
default settings, 3-21
Device tab default settings (table), 3-3
Device tab settings (table), 3-22
General tab settings (table), 3-21
PCI tab default settings (table), 3-4
PCI tab settings (table), 3-23
PCI-MXI-2, 3-25
Device Bus tab settings (table), 3-25
General Bus tab settings (table), 3-25
MXI-2 Bus tab settings (table), 3-26
PCI Bus tab settings (table), 3-26
Shared Memory Bus tab settings
(table), 3-25
shared memory tab default settings
(table), 3-4
Shared Memory tab settings (table), 3-22
SMB tab default settings (table), 3-5
SMB tab settings (table), 3-23
VXI bus tab default settings (table), 3-4
VXI Bus tab settings (table), 3-22
VXI-MXI-2, 3-23
Device tab settings (table), 3-23
General tab settings (table), 3-23
MXI-2 tab settings (table), 3-24
VXI Bus tab settings (table), 3-24
memory, shared, 4-8
MITE EEPROM
See also EEPROM
configuration, 3-6
power on self configuration, 3-7
figure, 3-7
user/factory configuration, 3-6
N
National Instruments
software, 1-3
support and services, D-1
NI VXIpc-882
BIOS configuration, 3-13
connectors, 5-1
COM1 connector and signals, 5-4
DVI-I connector and signals, 5-2
Ethernet connector
location and signals, 5-5
ExpressCard/34 connector and
signals, 5-12
GPIB (IEEE 488.2) connector and
signals, 5-11