Chapter 3 Configuration and Default Settings
© National Instruments Corporation 3-3 NI VXIpc-882 User Manual
Note Do not adjust any jumpers or switches not listed in Table3-1 or that are not
documented in this manual unless directed by National Instruments. Other configuration
jumpers are shown in the event National Instruments technical support needs to make
adjustments to your settings.
Default Software Settings
The following hardware configurations are available through
Measurement & Automation Explorer (MAX).
Table 3-1. NI VXIpc-882 Controller Hardware Default Settings
Jumper Description Setting
W2 SMB CLK10 DIR 1–2 In (Default)
2–3 Out
W3 External CLK10 Source Select 1–2 SMB (Default)
2–3 Trigger Card
W4 CLK10 Source Select 1–2 Internal Osc. (Default)
2–3 External Source
W5 MITE Configuration 1–2 Factory
2–3 User (Default)
W7 Trigger Card CLK10 Direction 1–2 Out
2–3 IN (Default)
W8 MITE Self Configuration 1–2 Disable
2–3 Enable (Default)
J2 Slot 0 Detect 1–2 Non-Slot 0
3–4 Auto Detect (Default)
5–6 Slot 0
Table 3-2. MAX Device Tab Default Settings
Editor Field Default Setting
Device class Message-based
Number of handlers 1