Chapter 2 Installation
© National Instruments Corporation 2-7 NI VXIpc-882 User Manual
ExpressCard/34
This section provides information on the installation and removal of
ExpressCard/34 modules.

Installing an ExpressCard/34

You can install an ExpressCard/34 module while the NI VXIpc-882 is
running. The NI VXIpc-882 will automatically detect the card.
ExpressCard/34s are generally marked with a symbol or a label to indicate
which end to insert into the slot. The cards are keyed to prevent incorrect
insertion.
To install an ExpressCard/34, complete the following steps.
1. Hold the card so the top side is facing left.
2. Insert the card until it is completel y seated in its connector. The
connector has an automatic eject mechanism. If you insert the card and
it is ejected, simply re-insert the card until it is seated.
If you encounter too much resistance, do not force the card. Check the card
orientation and try again.
The NI VXIpc-882 will automatically recognize the ExpressCard/34 and
load the appropriate driver(s). Third-party cards may require that you
install additional drivers. Contact your ExpressCard/34 vendor for more
information.
Caution The ExpressCard/34 interface is ESD sensitive. An electrostatic shock on the
ExpressCard/34 module while it is inserted may cause the controller to lock-up or reboot.

Removing an ExpressCard/34

To remove the ExpressCard/34 module push in the module and then release
to eject the card. Slide the card out of the slot.
Caution To avoid data loss and other potential issues, stop communication with your
ExpressCard/34 device before removing it from the NI VXIpc-882. In Windows, use the
Safely Remove Hardware tool to safely stop the ExpressCard/34.