Chapter 3 Configuration and Default Settings
© National Instruments Corporation 3-23 NI VXIpc-882 User Manual
You can use the PCI tab to set various configurations associated with the
PCI resources your VXI interface uses. Table 3-11 lists the default settings
for this tab on your VXIpc controller.
You can use the SMB tab to configure the options associated with the SMB
connectors on the front panel of your VXIpc controller. Table3-12 lists the
default settings for this tab on your VXIpc controller.
VXI-MXI-2 Default Settings
This section summarizes the software default settings for the VXI-MXI-2.
This information is included for your convenience in case you have any of
these modules in your system.
Table 3-11. VXIpc MAX PCI Tab Default Settings
Setting Default Value
User Window: Enable Low-Level
Register Access API Support
Checked
User Window Size 2 MB
DMA Setting: Enable DMA on
this Controller
Enabled
Table 3-12. VXIpc MAX SMB Tab Default Settings
Setting Default Value
Clock 10 Settings: Enable 50 Ohm
Termination
Not Checked
Table 3-13. VXI-MXI-2 General Tab Default Settings
Setting Default Value
Common Board Configurations Current Board Configuration
Table 3-14. VXI-MXI-2 Device Tab Default Settings
Setting Default Value
Logical Address Selection Use DIP Switch to Set the
Logical Address
Shared Memory: Address Space A24