From the Filter card, some, all, or none of the protocols listed may be selected for filtering out:

IP protocol

IPX protocol

NetBEUI protocol

AppleTalk protocol

Other protocols

Internet Multicast Frames

Selecting a protocol to be filtered will activate the AP’s protocol filtering immediately on clicking OK. Clicking Reset AP is not required. If, after filtering a protocol, your network is not functioning as before, it’s likely the protocol is required on the network and you should disable the filter for that protocol.

TFTP:

The Access Point supports remote firmware upgrades using TFTP (Trivial File Transfer Protocol). You may customize TFTP services with the following options:

Figure 28. AP Setting/TFTP

30InstantWave High Rate 11Mbps Access Point