
Troubleshooting continued
Symptoms(continued)
Symptom | Point to check | |
|
| |
The temperature of the display panel surface is | The LCD display panel works by lighting phosphors. In some cases, this | |
warm. | may cause the temperature of the panel surface to increase. Please note | |
| that this is not a malfunction. | |
|
| |
Points that do not light, points with brightness | ||
different from that of the periphery, points with | However over the life of the LCD panel, a few pixel elements may fail. | |
color different from that of the periphery, etc. | This is not to be considered a defect in the panel. | |
|
| |
Coarse horizontal stripes appear in FULL display. | Adjusting the Clock Phase will reduce the horizontal stripes. (RGB input) | |
| ||
|
| |
The screen flickers in the form of horizontal lines | If the frequency from the computer is below 85Hz, try a higher frequency | |
oscillating up and down. | (to a maximum limit of 85Hz). There may be a slight attenuation of the | |
(PC INPUT MODE only) | current image. | |
|
| |
The top surface of the monitor heats up. | When used for long periods of time, the top surface of the monitor may | |
| heat up. This is not a malfunction. | |
|
| |
Text characters are displayed with varying | The thickness of characters and lines may vary when images with a | |
thickness. | vertical resolution greater than 720 lines are displayed; however this is | |
| not a malfunction. | |
|
| |
The display does not seem bright enough. | The ambient temperature of the monitor may be low. Ambient temperatures | |
less than about 15° degrees, may cause lower luminance. | ||
| ||
| The panel protection circuit automatically lowers the luminance, and is | |
| not a malfunction. The luminance will be restored when power is turned | |
| on for a while. | |
|
| |
The display does not seem bright enough. (RGB | The | |
input) | to PC mode, the luminance is lowered by about 10% than when set as Movie | |
| mode. This is not a malfunction. If you do not mind flicker on the display, | |
| please switch to Movie mode. | |
|
|
31