NEC LCD1770V, LCD1770NX, LCD1770NXM Specifications -continued, MultiSync LCD1770NX, Monitor

Specifications –continued

Monitor		MultiSync® LCD1770NX		Notes
Specifications		Monitor
LCD Module	Diagonal :	17.0 inch		Active matrix; thin film transistor (TFT)
Viewable Image Size :		17.0 inch		liquid crystal display (LCD); 0.264 mm dot
Native Resolution (Pixel Count) :		1280 x 1024		pitch; 250cd/m2 white luminence;
				500:1 contrast ratio, typical
Input Signal	Video :	ANALOG 0.7 Vp-p/75 Ohms		Digital Input: DVI
	Sync :	Separate sync. TTL Level
		Horizontal sync. Positive/Negative
		Vertical sync. Positive/Negative
Display Colors		16,194,277		Dependent on display card used.
Maximum	Left/Right :	80°/80° (CR>5)
Viewing Angles	Up/Down :	85°/75° (CR>5)
Synchronization	Horizontal :	31.5 kHz to 81.0 kHz (Analog)		Automatically
Range		31.5 kHz to 69.0 kHz (Digital)		Automatically
	Vertical :	56.0 Hz to 75.0 Hz		Automatically
Resolutions Supported		720 x 400*1 :VGA text		Some systems may not support all modes listed.
		640 x 480*1 @ 60 Hz to 75 Hz
		800 x 600*1 @ 56 Hz to 75 Hz
		832 x 624*1 @ 75 Hz
		1024 x 768*1 @ 60 Hz to 75 Hz
		1152 x 870*1 @ 75 Hz
		1280 x 1024 @ 60 Hz to 75 Hz (Analog)	......... NEC-Mitsubishi Electronics Display cites
		1280 x 1024 @ 60 Hz (Digital)		recommended resolution at 60 Hz for
				optimal display performance.
Active Display Area	Horizontal :	337.9 mm/13.3 inches
	Vertical :	270.3 mm/10.6 inches
USB Hub	I/P:	USB Specification Revision 2.0
	Port:	Upstream 1
		Downstream 4
	Load Current:	Maximum 0.5A per port
Power Supply		100 Ð 240 V ~ 50/60 Hz
Current Rating		0.7 Ð 0.36A
Dimensions		367.0 mm (W) x 362.5-472.5 mm (H) x 198.0 mm (D)
		14.4 inches (W) x 14.3-18.6 inches (H) x 7.8 inches (D)
Weight		6.1 kg
		13.4 lbs
Environmental Considerations
Operating Temperature :		5°C to 35°C/41°F to 95°F
	Humidity :	30% to 80%
	Feet :	0 to 10,000 Feet
Storage Temperature :		-10°C to 60°C/14°F to 140°F
	Humidity :	10% to 85%
	Feet :	0 to 30,000 Feet

*1 Interpolated Resolutions: When resolutions are shown that are lower than the pixel count of the LCD module, text may appear different. This is normal and necessary for all current flat panel technologies when displaying non-native resolutions full screen. In flat panel technologies, each dot on the screen is actually one pixel, so to expand resolutions to full screen, an interpolation of the resolution must be done.

NOTE: Technical specifications are subject to change without notice.

15

LCD17PISAManual080604.p65 15 8/6/04, 5:15 PM