Middleby Marshall Model PS536 English, 4 Electrical specifications for gas ovens per oven cavity

SECTION1-DESCRIPTION

Table 1-3: Electrical specifications for electric ovens (per oven cavity)

Main Blower	Control				Current Draw			k W
Voltage	Circuit Voltage	Phase	Freq.	L1	L2	L3	N	Rating	Poles	Wires
208V	120V conv. speed control,	3 Ph	60 Hz	50A	50A	50A	--	16.0 kW	4 Pole	4 Wire
	drive motor, contactor,							at 208V		(3 hot, 1 gnd)
	& temp. control; all others 208V
230V	120V conv. speed control,	3 Ph	60 Hz	45A	45A	45A	--	16.0 kW	4 Pole	4 Wire
	drive motor, contactor,							at 230V		(3 hot, 1 gnd)
	& temp. control; all others 230V
380V *	120V conv. speed control,	3 Ph	50 Hz	25A	25A	28A	5A	16.0 kW	4 Pole	5 Wire (3 hot,
	drive motor, contactor,							at 380V		1 neutral, 1 gnd)

&temp. control; 380V heating elements; all others 240V

* 380V model is not approved by or .

ENGLISH

Table 1-4: Electrical specifications for gas ovens (per oven cavity)

Main Blower	Control			Current
Voltage	Circuit Voltage	Phase	Freq.	Draw	Poles	Wires
208/240V	120V conv. speed control,	1 Ph	60 Hz	6A	3 Pole	4 Wire (2 hot, 1 neut, 1 gnd)
	drive motor, contactor,
	& temp. control; all others
	as per line (208/240V)

Table 1-5: Gas orifice and pressure specifications (per oven cavity)

				Orifice (Manifold)
Gas Type	Main Orifice I.D.	Pilot Orifice I.D.	Supply (Inlet) Pressure	Pressure
Natural	0.0935” (2.3749mm, #42 drill)	0.018” (0.46mm)	4-7” W.C. (9.95-17.4mbar) *	3.5” W.C. (8.7mbar)
Propane	0.0520” (1.3208mm, #55 drill)	0.018” (0.46mm)	11-14” W.C. (27.4-34.9mbar) *	10.5” W.C. (24.9mbar)

*The gas supply pressures shown are for ovens installed in North America. The required gas supply pressures of other locations are dependent on the local gas type and on all applicable local codes.

IMPORTANT

Additional electrical information is provided on the oven's serial plate, and on the wiring diagram inside the machinery compartment.

5