CLR2060 — Clear Ice Maker | ™ |
| |
|
|
7 Prepare Power Supply
8 Level the Unit
Electrical Specifications
CAUTION
Electrical installation must observe all state and local codes. This unit requires connection to a grounded (three-
Leveling Information
IMPORTANT
It is extremely important that the unit is level. If it is not level, the ice mold will not fill evenly.
prong), polarized receptacle that has been placed by a qualified electrician.
The unit requires a grounded and polarized 115 VAC,
60 Hz, 15A power supply (normal household current). An individual, properly grounded branch circuit or circuit breaker is recommended. GFCI (ground fault circuit interrupter) is usually not required for fixed location appliances and is not recommended for your unit because a GFCI could be prone to nuisance tripping. However, be sure to consult your local codes.
See Figure 41 for recommended receptacle location. Plugging the unit into a receptacle located behind an adjacent cabinet will allow the CLR2060 to be more easily serviced with
Preferred |
|
Location | Acceptable |
for CLR2060 | |
Receptacle | Location |
| 24" |
| 7" |
| 1" |
Figure 41 |
|
WARNING
SHOCK HAZARD — Electrical Grounding Required.
•Never remove the round grounding prong from the plug and never use a
•Never use an extension cord to connect power to the unit.
Go on to 8 Level the Unit.
A unit that is not level can cause a reduction in ice rate, uneven sized cubes or water spilling into the storage area, which will cause the ice in the bin to melt prematurely (see Figure 42).
Remember that floors near drains have a tendency to slope towards the drain.
1.Use a level to check the levelness of the ice maker from front to back and from side to side. Level should be placed along top edge and side edge as shown (see Figure 43).
Figure 42 |
Check |
Level |
Figure 43 |
16 | 02/2005 |
