U-Line CLR2060 manual Reversing the Door

Figure 4

™	CLR2060 — Clear Ice Maker
Reversing the Door	4. Remove the two door closer inserts from the existing
(Black and White Units Only)	bottom hinge and install as shown on the new bottom
	hinge (see Figure 8).

All U-Line units (except Stainless Steel models) may be left- or right-hand opening. The door opening is easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used on the bottom of the other side and the bottom hinge hardware will be used on the top of the other side (see Figure 4).

To reverse the door:

Hinge

Screw

Pin

Figure 7

Door

Closer

Inserts

Figure 8

1.Remove top hinge screw pin from door (7/64"

Allen wrench or Phillips screwdriver, depending on your unit’s

construction) (see Figure 5). Remove door by tilting forward and lifting off bottom hinge pin.

2.Remove plastic screw plugs (3 each, top and bottom) from new hinge location. Do not discard (see Figure 6).

5.Remove existing bottom hinge (3 screws) and remount on opposite side TOP. Remove hinge screw pin.

6.Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.

7.With bottom of door facing up, remove pivot plate (2 screws), flip over, and remount on opposite side of door (see Figure 9). Be sure notch in plate faces center.

Figure 5

Screw Plugs

Figure 6

Figure 9

3.Remove top hinge (3 screws), reinstall hinge screw pin, and remount on opposite side BOTTOM (see Figure 7).

8.Holding door upright with top of door tilted forward, place hole of door pivot plate on bottom hinge screw pin (see Figure 10).

9.Tilt top of door into position in top hinge and install top hinge screw pin.

10.Install plastic screw plugs removed in Step 2 in old hinge holes (3 each, top and bottom).

Figure 10

02/2005 5 www.U-LineService.com