™ | CLR2060 — Clear Ice Maker |
|
CAUTION
In the event of a power outage, restricted drain or pump failure, the failure to use the
3.Carefully bend the water supply line into position and connect the line to the solenoid valve (see Figure 39). Avoid kinking the water supply line.
pump with the above listed specifications, could result in substantial water leakage and pooling with severe and costly water damage and related consequential damages and harm.
Water Supply Connection
When connecting the water supply, follow these guidelines:
• Review the local plumbing codes before you install the | |
| unit. |
• Connect to the cold water supply. | |
• | The water pressure should be between 20 and 120 psi. |
• | Install a |
Water Line | Power |
Cord | |
Figure 39 |
|
Figure 40 |
line. |
• Connect sufficient tubing to the unit so that tubing |
may be looped, allowing the unit to be removed for |
cleaning and servicing (see Figure 40). However, make |
certain that the tubing is not pinched or damaged |
during installation. |
• |
installation. |
To connect to water supply:
1.Install the 1/4 inch OD copper water line from the main water source (see Figure 37).
IMPORTANT
Normal operation creates some vibration. A water supply line contacting cabinet wall may cause excessive noise during operation or damage to the line.
4.For recessed installations, allow extra water supply line length to provide slack for easy removal from the recessed area (see Figure 40). This will also safeguard against kinking the line.
5.Go on to 7 Prepare Power Supply
Water |
Connection |
Figure 37 |
Figure 38 |
2.Locate the compression fitting and ferrule packed with this guide. Slide the compression fitting and ferrule over the
02/2005 | 15 |
