™ | CLR2060 — Clear Ice Maker |
|
Pivot Post
Wood Panel Top Hinge Plate
(5/8" Longer than Existing Top Hinge Plate)
Flat Head Screw
Three Places
Top Pivot Plate
Door Panel
Figure 24
3.Install the pivot post into the new Replacement Bottom Hinge (using the 7/64" hex key or Phillips screwdriver) and install the hinge onto the unit.
4.Replace the door closure assembly onto the bottom pivot post (see Figure 25). Be sure that bosses on closers align with holes in hinge and hinge plate.
| Existing |
| Door |
Door Closure Top | Boss |
Door Closure Bottom |
|
| x |
5 Adjust Door
Checking Door Alignment
The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation.
IMPORTANT
Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 26).
1/8" |
Figure 26 |
1.Compare the top edge of the door to the top edge of the cabinet.
2.If the door edge is 1/8" below and parallel to the top of the cabinet, go on to 6 Prepare Plumbing. If it is not, note whether the side opposite the hinge needs to be moved UP or DOWN, and use the following procedure.
Adjusting Door Alignment
| |
Boss | Three Places |
| Wood Panel Bottom Hinge Plate |
Pivot Post | (5/8" Longer than Existing Bottom Hinge Plate) |
Figure 25
IMPORTANT
Pivot posts must be cleaned. Closers must also be clean and greased to ensure proper operation.
5.Place the modified door onto the pivot post.
6.Position door and install the pivot post into the top hinge (using the 7/64" hex key or Phillips screwdriver).
7.Adjust door as needed for proper closure. Go on to 5 Adjust Door.
1.Remove top hinge screw pin (7/64" Allen wrench or Phillips screwdriver, depending on your unit’s construction, see Figure 27). Remove door by tilting forward and lifting off bottom hinge pin.
2.With door
Figure 27 |
02/2005 | 11 |
