™ | CLR2060 — Clear Ice Maker |
|
4.Drill hole for upper door hinge (top of panel) (see Figure 16, Top View).
0.177" diameter
(#16 drill) x 11/16" deep
5.Drill hole for lower door hinge (see Figure 16, Bottom View).
5/16" diameter x 1/4" deep
4.Remove the top handle and discard. (This handle will be replaced with the Modified Handle included in the Full Overlay Door Panel Kit.)
5.Remove the two screws located on both sides of the lower handle. Remove the handle.
6.Attach the Modified Handle to the lower handle using the three screws removed in Step 3. Set aside.
7.Slide the existing door panel out of the doorframe.
CAUTION | Attaching the Full Overlay Panel |
|
It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed.
Installation Instructions
Removing Existing Door
1.Remove top hinge screw pin (7/64" hex key or Phillips screwdriver, depending on your unit’s construction). Remove the door by tilting forward and lifting off the bottom hinge pin.
2.Pull door gasket out of the groove (top edge of door only). Start in the middle and pull outward, moving toward the edge (see Figure 17). This may take some force.
1.Tap nylon inserts into the top holes drilled in the overlay panel. Use two #6 screws to attach top pivot bracket to the overlay panel (see Figure 19).
Typical Wood |
Panel |
#6 X 5/8" |
Flat Head Screw |
Two Required |
Top Pivot |
Plate |
8 mm Plug Insert |
Two Required |
Figure 19 |
Figure 17 |
New Handle |
Old Handle |
Figure 18 |
2.If a
3.Place and tape the existing door panel on the back of the overlay panel (see Figure 20) and drill holes through both panels according to Figure 21. Remove tape adjoining the panels and enlarge the six holes in the overlay panel using a 0.201" (#7) drill.
3.Remove the three screws located on the back of the handle (see Figure 18).
02/2005 | 9 |
