U-Line CLR2060 manual Locally-Installed Drain Pump

CLR2060 — Clear Ice Maker ™

To check and test hose connections:

1.Make certain the unit is not plugged into an electrical outlet.

2.Carefully push the power cord grommet through the hole in the back panel (see Figure 35).

Back

Panel

Screws

Drain

Fitting

Water

Connection

Grommet

Power

Cord

Figure 35

3. Remove 12 screws and back panel.

5.Place a suitable container beneath the pump’s discharge tube. (The bucket must be able to hold a minimum of one gallon.)

6.Plug the ice maker power cord into a properly grounded, polarized electrical outlet.

7.Verify pump operation by pouring one gallon of water into the ice storage bin of the ice maker. The pump should energize and pump the water into the container.

8.At this time, verify that all tube and clamp connections are tight and leak free.

9.Unplug unit power cord from electrical outlet.

10.Reinstall back panel.

To connect to drain:

1.Attach the 5/8-inch ID drain connection on the back of the unit to a 5/8-inch OD rigid tube, using a worm clamp.

2.Attach the other end of the rigid tube to your 5/8-inch ID drain line with a worm clamp.

3.Insulate the drain line, if necessary to prevent condensation. Go on to Water Supply Connection.

WARNING

Locally-Installed Drain Pump

Back panel serves as a guard. DO NOT put your hands inside the ice maker cabinet or attempt to touch any components except the discharge tube during testing. Failure to follow this warning could result in serious personal injury or death.

4.Check that the clamps and hose connections are tight at the following areas (see Figure 36):

•Discharge tube (A)

•Drain tube (B)

•Vent tube (C)

B	B
C	C
	A
Back View	Side View
Figure 36

If a gravity drain connection is not possible, and you have not purchased the CLR2060 with factory-installed pump, we strongly recommend the use of the U-Line P60 drain pump. The U-Line P60 drain pump is available through your Dealer, or direct from U-Line with complete installation instructions. If a pump other than the U-Line P60 drain pump is to be used, it must meet the following specifications:

•It must be UL listed and have a UL listed, 120 VAC, 3-wire grounded power cord.

•It must have overall maximum outside dimensions of 8-3/4" wide x 5-3/4" deep x 7-3/4" high.

•It must have a minimum flow rate of 15 gallons per hour at 10 feet of lift.

•It must have a sealed sump which does not allow water leakage in the case of a power outage, restricted drain or pump failure.

•It must have a check valve in the discharge line to prevent waste water return to the pump.

•It must have an overflow protection control which will shut off power to the ice maker in the event of a pump failure.

•It must have an operating temperature range of 50°F to 110°F (10°C to 40°C).

www.U-LineService.com 14 02/2005