NEC LCD205WXM, LCD225WXM English, Raise and Lower Monitor Screen, Specifications, Tilt and Swivel

English

Stand

Base		Cable management cover
	Figure A.4
Power Cable	Input (VGA)
		Input (Audio)
		Input (DVI)
Cable
management
cover
Connect to Computer	Figure B.1	Headphone
audio output

Power Button

3.Remove the Cable management cover (Figure A.4).

4.Connect all cables to the appropriate connector on the back of the monitor (Figure B.1). Connect Headphones

(not included) to the appropriate connector at the rear side of the monitor, if desired (Figure B.1).

5.Connect one end of the power cord to the monitor and the other end to the power outlet. Position the Video Signal Cable, Audio cable and power cord between the holes on the Stand.

6.To attach the Cable management cover, insert the tabs of the Cable management cover into the holes on the Stand and slide the Cable management cover downward into place (Figure B.1) making sure that the tabs are completely secure.

NOTE: Adjust the position of the cables that are placed under the Cable management cover to avoid damaging the cable or monitor.

NOTE: Please refer to the Caution section of this manual for proper selection of power cord.

7.Turn on the monitor with the front power button and the computer (Figure C.1).

8.No-touch Auto Adjust automatically adjusts the monitor to optimal settings upon initial setup for most timings (Analog input only). For further adjustments, use the following OSD controls:

¥Auto Contrast

¥Auto Adjust

Refer to the Controls section of this UserÕs Manual for a full description of these OSD controls.

NOTE: If you have any problem, please refer to the Troubleshooting section (CD-ROM).

Raise and Lower Monitor Screen

Figure C.1

Non-abrasive surface

Figure R.1

Figure R.3

Replace screws

100 mm

Specifications

4-SCREWS (M4)

MAX depth: 8.5mm If use other screw, check length of screw.

Figure RL.1

Figure R.2

Figure TS.1

Thickness

of Bracket (Arm)

2.0 ~ 3.2 mm

Tighten all

screws

100 mm

The monitor may be raised or lowered. To raise or lower screen, place hands on each side of the monitor and lift or lower to the desired height (Figure RL.1).

NOTE: Handle with care when raising or lowering the monitor screen.

Tilt and Swivel

Grasp both sides of the monitor screen with your hands and adjust the tilt and swivel as desired (Figure TS.1).

NOTE: Handle with care when tilting and swivelling the monitor screen.

Remove Monitor Stand for Mounting

To prepare the monitor for alternative mounting purposes:

1.Disconnect all cables.

2.Place monitor face down on a non-abrasive surface (Figure R.1).

3.Remove the 4 screws connecting the monitor to the stand and remove the stand as indicated (Figure R.2). The monitor is now ready for mounting in an alternative manner.

4.Connect all cables to the back of the monitor (Figure R.3).

5.Reverse this process to re-attach stand.

NOTE: Use only VESA-compatible alternative mounting method.

NOTE: Handle with care when removing monitor stand.

Connecting a Flexible Arm

This LCD monitor is designed for use with a flexible arm.

Please use the attached screws (4pcs) as shown in the picture when installing. To meet the safety requirements, the monitor must be mounted to an arm which guaranties the necessary stability under consideration of the weight of the monitor. The LCD monitor shall only be used with an approved arm (e.g. GS mark).

Weight of LCD assembly: 6.0 kg (MAX) (LCD205WXM) 6.3 kg (MAX) (LCD225WXM)

English-2

01_English 2 6/6/07, 8:36 AM