6. Using
Setting ID to the Projector [CONTROL ID]
NOTE: This function is available only when the optional remote control (NP02RC) is used. This function will not work with the remote control included with the NP3250/NP2250/NP1250/NP3250W projector.
You can operate multiple projectors separately and independently with the same single remote control. To do so,you have to assign an ID number to each projector.
CONTROL ID NUMBER.......... | Select a number from 1 to 254 you wish to assign to your projector. |
CONTROL ID.......................... | Select [OFF] to turn off the CONTROL ID setting and select [ON] to turn on the CONTROL ID |
| setting. |
NOTE:
•Selecting [ON] for [CONTROL ID] will not make the remote control supplied with the projector inoperable. The buttons on the projector cabinet can be used. Neither can you operate the projector by using the optional remote control NP01RC that does not has the CONTROL ID function.
•Pressing and holding the ENTER button on the projector cabinet for 10 seconds will display the menu for canceling the Control ID.
•Your setting will not be affected even when [RESET] is done from the menu.
Using the Remote Control to change IDs
1.Press the ID SET button on the remote control. The CONTROL ID screen will be displayed.
If the projector can be operated with the current remote control ID, the [ACTIVE] will be displayed. If the projector cannot be operated with the current remote control ID, the [IN- ACTIVE] will be displayed. To operate the inactive projector, assign the ID by using the following procedure (Step 2).
2.Press one of 0 to 9 buttons while pressing and holding the ID SET button on the re- mote control.
The range of IDs is from 1 to 254.
To clear the ID:
Press the CLEAR button while pressing the ID SET button.
NOTE:
•Setting “0 (zero)” means to clear the ID.
•You cannot operate the projector using the remote control if the remote ID is not the same as the projector ID.
•No ID means that all the projectors can be operated together with a single remote control. To set “No ID” enter “000” or press the CLEAR button.
3.Release the ID SET button.
The updated CONTROL ID screen will be displayed.
ENTER
| ||
VOLUME | MAGNIFY | PAGE |
|
| UP |
|
| DOWN |
PICTURE | LAMP MODE | ASPECT |
3D REFORM | FREEZE | |
| FOCUS |
|
ID SET LENS SHIFT /ZOOM | HELP | |
ID
OFFON
| POWER | |
| COMPUTER | AUTO ADJ. |
1 | 2 | 3 |
VIDEO | COMPONENT HDMI | |
VIEWER | NETWORK | PIP |
1 | 2 | 3 |
4 | 5 | 6 |
7 | 8 | 9 |
ID | 0 | CLEAR |
|
| |
MENU |
| EXIT |
| ENTER |
|
| ||
VOLUME | MAGNIFY | PAGE |
|
| UP |
|
| DOWN |
PICTURE | LAMP MODE | ASPECT |
3D REFORM | FREEZE | |
| FOCUS |
|
ID SET LENS SHIFT /ZOOM | HELP | |
ID
NOTE: The IDs can be cleared in a few days after the batteries are run down or removed.
125