2. Installation and Connections

When Viewing a DVI Digital Signal (LT380 only)

To project a DVI digital signal, be sure to connect the PC and the projector using a DVI-D signal cable (not supplied) before turning on your PC or projector. Turn on the projector first and select DVI (DIGITAL) from the source menu before turning on your PC.

Failure to do so may not activate the digital output of the graphics card resulting in no picture being displayed. Should this happen, restart your PC.

Do not disconnect the DVI-D signal cable while the projector is running. If the signal cable has been disconnected and then re-connected, an image may not be correctly displayed. Should this happen, restart your PC.

NOTE:

Use a DVI-D cable compliant with DDWG (Digital Display Working Group) DVI (Digital Visual Interface) revision 1.0 standard. The DVI-D cable should be within 10 m (394") long.

The DVI (DIGITAL) connector (COMPUTER 3) accepts VGA (640x480), SVGA (800x600), 1152x864, XGA (1024x768) and SXGA (1280x1024 @ up to 60Hz).

COMPUTER 3 IN (DVI-D connector with HDCP)

AUDIO IN

 

 

USB

 

 

 

 

 

 

 

 

 

COMPUTER 3 IN

 

PC CARD

 

 

 

 

 

COMPONENT IN

 

 

AUDIO IN

COMPUTER 1 IN

COMPUTER 2 IN

Y

Cb/Pb

Cr/Pr

 

 

 

 

S-VIDEO IN

VIDEO IN

AUDIO IN

 

AUDIO OUT

MONITOR OUT

PC CONTROL

 

 

L/MONO

R

AC IN

DVI-D cable

Audio cable (not supplied)

PHONE

IBM VGA or Compatibles or Macintosh

What is HDCP/HDCP technology?

HDCP is an acronym for High-bandwidth Digital Content Protection. High bandwidth Digital Content Protection (HDCP) is a system for preventing illegal copying of video data sent over a Digital Visual Interface (DVI).

If you are unable to view material via the DVI input, this does not necessarily mean the projector is not functioning properly. With the implementation of HDCP, there may be cases in which certain content is protected with HDCP and might not be displayed due to the decision/intention of the HDCP community (Digital Content Protection, LLC).

14