3. Projecting an Image (Basic Operation)

￿Adjusting the Picture Size and Position

Place your projector on a flat level surface and ensure that the projector is square to the screen.

Lift the front edge of the projector to center the image vertically.

If the projected image does not appear square to the screen, use the Keystone feature for proper adjustment. (page 29, 38)

Rotate the front of the projector right or left (to the right in this example) to center the image horizontally on the screen.

Adjust the Tilt Foot1. Lift the front edge of the projector.

CAUTION:

Do not try to touch the ventilation outlet during Tilt Foot adjustment as it can become heated while the projector is turned on and during its cool down period after it is turned off.

2.Push up the Adjustable Tilt Foot Levers on the right and left sides of the projector to extend the adjustable tilt feet (maximum height).

3.Lower the front of the projector to the desired height.4.Release the AdjustableTilt Foot lever to lock the Adjustable tilt foot.

There is approximately 10 degrees (up) of adjustment for the front of the projector.

TIP: When [Auto Keystone] is turned on, adjusting the height of a projected image or changing projection angle will result in Auto Keystone function to work to quickly correct the vertical distortion. The [Key- stone] screen will be displayed.

For operating the [Keystone] screen, see "￿ Correcting Keystone Distortion" on page 29.

NOTE: Your "Keystone" correction data can be reset by pressing and holding the 3D REFORM button for a minimum of 2 seconds.

CAUTION:

Do not use the tilt-foot for purposes other than originally intended. Misuses such as using the tilt foot to carry or hang (from the wall or ceiling) the projector can cause damage to the projector.

1 2

Adjustable TiltFoot Lever

2

Adjustable Tilt Foot

Adjustable Tilt

Foot Lever

3 4

4

27