5. Using On-Screen Menu

Using Test Pattern [TEST PATTERN]

Displays the test pattern to check for image distortion at the time of the projector setup. Press the ENTER button to display the test pattern; press the EXIT button to close the test pattern and return to the menu. Menu operation and keystone correction are not possible when the test pattern is displayed.

[OPTIONS(1)]

[M350X/M300X/M260X/M230X/M300W/M260W/ [M420XV] M420X/M350XS/M300XS/M260XS/M300WS/

M260WS]

Setting Auto Adjust [AUTO ADJUST]

This feature sets the Auto Adjust mode so that the computer signal can be automatically or manually adjusted for noise and stability. You can automatically make adjustment in two ways: [NORMAL] and [FINE].

OFF ������������������������ The computer signal will not be automatically adjusted. You can manually optimize the computer signal. NORMAL���������������� Default setting. The computer signal will be automatically adjusted. Normally select this option.

FINE����������������������� Select this option if fine adjustment is needed. It takes more time to switch to the source than when [NOR- MAL]is selected.

Selecting Fan Mode [FAN MODE]

This option allows you to select three modes for fan speed: Auto mode, High speed mode, and High Altitude mode.

AUTO ��������������������� The built-in fans automatically run at a variable speed according to the internal temperature. HIGH���������������������� The built-in fans run at high speed.

HIGH ALTITUDE����� The built-in fans run at a high speed. Select this option when using the projector at altitudes approximately 5500 feet/1600 meters or higher.

When you wish to cool down the temperature inside the projector quickly, select [HIGH].

NOTE:

•It is recommended that you select High speed mode if you use the projector non-stop for consecutive days.

•Set [FAN MODE] to [HIGH ALTITUDE] when using the projector at altitudes approximately 5500 feet/1600 meters or higher.

•Using the projector at altitudes approximately 5500 feet/1600 meters or higher without setting to [HIGH ALTITUDE] can cause the projector to overheat and the protector could shut down. If this happens, wait a couple minutes and turn on the projector.

•Using the projector at altitudes less than approximately 5500 feet/1600 meters and setting to [HIGH ALTITUDE] can cause the lamp to overcool, causing the image to flicker. Switch [FAN MODE] to [AUTO].

•Using the projector at altitudes approximately 5500 feet/1600 meters or higher can shorten the life of optical components such as the lamp.

•Your setting will not be affected even when [RESET] is done from the menu.

87