NEC NC2500S 1-4.Names on the Remote Control

1. What’s in the Box? and the Names of the Projector Parts

1-4. Names on the Remote Control

2		1. POWER ON button
		Operate this button to turn on the power to your projector.
1		Press it three seconds or longer.
4	3	When turning on the power to your projector, first set the main
17		power switch to the main unit and the LPSU to ON, which puts
		your projector on standby. (See page 19)
6	7	2. POWER OFF button
		Operate this button to turn off (standby) the power to your
5		projector. Press it three seconds or longer.

8

9

1011

12

13

- - 15

16

14

3. Numeric buttons (1 to 0 buttons)

Use these buttons to enter alphanumeric characters. (See page 28)

4.TEST button

•Press this button, and a test pattern will be displayed.

Check the test pattern on the LCD screen by pressing the SELECT
/ button, then press ENTER to set your

selection.

To cancel the test pattern display, reselect the signal to project.

5.KEYSTONE / R button

Press the KEYSTONE(R) button while depressing the CTL button, then the red (R signal) of the test pattern will be turned off temporarily. Press this button again while depressing the CTL button, and the red (R signal) will be projected again.

6. AMPLITUDE / G button

Press the AMPLITUDE (G) button while depressing the CTL button, then the green (G signal) of the test pattern will be turned off temporarily.

Press this button again while depressing the CTL button, and the green (G signal) will be projected again.

7. ENTRYLIST / B button

Press the ENTRYLIST (B) button while depressing the CTL button, then the blue (B signal) of the test pattern will be turned off temporarily.

Press this button again while depressing the CTL button, and the blue (B signal) will be projected again.

8. POSI / LENS button

Press the POSI/LENS button while depressing the CTL button, to adjust the position of projected screen (Lens Shift Mode). (See page 28)

9.PICT / SHUT button

•Press this button to turn off image projection temporarily. Press it again, and the image will be projected again.

•Press the PICT / SHUT button while depressing the CTL button, then the douser sill operate to shut off the light for projection. The POWER indicator blinks in green while the douser is operating. Press this button again while depressing the CTL button to cancel the operation of the douser.

NOTE When GPIO Control is set to “Enable”, it is not possible to turn the power on/off and the douser function.

10. MENU button

Operate this button, and menus for various settings and adjustments will be displayed on the LCD screen. (See page 26)

12