CHAPTER 2 DATA PROGRAMMING SHEET
How to Read This Chapter
HOW TO READ THIS CHAPTER
The data programming sheets are given in numerical and alphabetical order of the command code.
For programming procedure, see the CAT mode operation procedure below each data sheet. In each sheet, the following symbols are used.
: Initial data which is automatically loaded into the memory, after system initialization by setting position “B” on SW3 of the MP, followed by a reset.
INITIAL | : Commands that require a reset of the MP card after data setting. |
AP00 INITIAL : Commands that require a reset of the AP00 card after data setting.
AP01 INITIAL : Commands that require a reset of the AP01 card after data setting.
DCH INITIAL : Commands that require a reset of the DCH card after data setting.
DTI INITIAL : Commands that require a reset of the DTI card after data setting.
DBM INITIAL : Commands that require a reset of the DBM card after data setting.
Page 22 | NEAX2000 IVS2 Office Data Programming Manual |
