INTRODUCTION
Data Programming Procedure
DATA PROGRAMMING PROCEDURE
The following table shows the procedure and the outline of the office data programming for the system.
The office data specified in this manual are entered to the system through the Customer Administration Terminal (CAT) or Maintenance Administration Terminal (MAT).
STEP | WORK | REMARKS |
|
|
|
1. | Obtain the customer’s requirements, and |
|
| fill in the customer specifications sheets |
|
| in CHAPTER 1. |
|
|
|
|
2. | Allocate the LC, TRUNK and other | For mounting conditions of each card, |
| interface cards to the Port Assignment | refer to the Installation Procedure |
| Table in CHAPTER 1. | Manual. |
|
| For port assignment conditions of each |
|
| card, refer to the Command Manual |
|
| (CM10). |
|
|
|
3. | Fill in the data programming sheets in | For the detailed information on each |
| CHAPTER 2 with the Customer | Command, refer to the Command |
| Specifications Sheet and Port | Manual. |
| Assignment Table. |
|
|
|
|
4. | Check if data on all the programming |
|
| sheets are correct and consistent with |
|
| the customer specifications. |
|
|
|
|
5. | Specify the switch setting on the boards | For the function of each switch on the |
| with Switch Setting Table in the | cards, refer to the Installation Procedure |
| Installation Procedure Manual. | Manual. |
|
|
|
NEAX2000 IVS2 Office Data Programming Manual | Page 3 |
