4. Attaching Wireless LAN Card

4. Attaching Wireless LAN Card

Insert the wireless LAN card into the PC card slot on the rear panel of the projector.

Important

The wireless LAN card must be inserted into the PC card slot in the correct direction. It cannot be inserted in the reverse direction. If the card is inserted in the reverse direction with excessive force applied, the pins in the projector and the PC card slot may break. Be sure to insert the wireless LAN card with its label facing up.

Before touching the LAN card, touch a metallic object (such as a door knob or aluminum window frame) to discharge the static electricity from your body.

Always insert or remove the wireless LAN card when the main power is turned off. Failure to do so may cause projector malfunction or damage to the wireless LAN card. If the projector will not work correctly, turn off the projector, wait 30 seconds, and turn it back on.

Setting card in PC card slot

1Press POWER ON/STAND BY button to set the projector to Stand-by mode, press the “O (off)” side of the main power switch of the projector.

2With the label on the wireless LAN card facing up, slowly insert the card into the slot horizontally.

Note

Do not apply any excessive force while inserting the card.

SELECT

 

 

3D

REFORM

 

 

 

 

AUTO

ADJUST

 

 

SOURCE

ON/S

TAND

 

 

BY

4

Attaching Wireless LAN Card

11

Page 13
Image 13
NEC NP2000, NP1000 setup guide Attaching Wireless LAN Card, Setting card in PC card slot