Toshiba FC-22 manual Relationship between wound turns and wire holder jigs

Note :

1.When winding the wires on the pulleys, take the following precautions:

·Do not wind the wire on the pulley with the wire twisted.

·Wind the wire strongly so that all the turns of the wire are in firm contact with the surface of the pulley.

·Each time you wind a turn on the pulley, push it to the preceding turn so that all the turns are closely wound.

2.When fitting wire holder jigs, take care so that the turns wound on the pulleys do not move or unwind.

<Relationship between wound turns and wire holder jigs>

3-mm dia.

ball terminal Front side

Wire holder jigs

Pulley

No gap should exist.

e.g. Front side

Rear side

Wire holder jig

January 2000 © TOSHIBA TEC 1 - 79 FC-22 ADJUSTMENT