Toshiba FC-22 manual Long size 439 441 443 445 Short size 440 442 444 446, 447 448, 449

1. 6. 1 Paper alignment (paper buckle) at the main registration roller

If the paper feed roller has prematurely become defective, it is possible to extend its service life, if necessary, by increasing the aligning amount, as a temporary measure until a replacement becomes available.

<Operation procedure> (Use codes 439 to 452 in adjustment mode “05”.)

		Copier cassettes
	1st	2nd	3rd	4th
	cassette	cassette	cassette	cassette
Long size	439	441	443	445
Short size	440	442	444	446

ADU

447

448

LCF

449

Bypass feeding

450

Thick paper2

451

Thick paper3

452

(1)

0 5

POWER

Digital keys

Paper

source code

	(Current value displayed)		Digital keys
START		(Input a new value.)

	SET
			ENERGY SAVER	START
	or	(Select a paper source)
INTERRUPT			(Test copy)

(Stored in memory)

(2) Check for any transfer void or “Z” fold. If a trans- Transfer void fer problem is present, try the values in de-

scending order as “31”→“30”→”29"··· until the transfer void disappears. At the same time, confirm that any paper jam has not occurred. Also, when the aligning amount has been in- creased, this may increase the scraping sound

which occurs when the paper scrapes on the

“Z” fold

mylar sheet as it is transferred by the regis- tration roller. If this scraping sound is irritat- ing, try reducing the aligning amount.

(3)Do the same for ADU, LCF, bypass feeding, thick paper 2 and thick paper 3.

Power OFF/ON

Note:

When paper thinner than specified is used, paper jams may occur frequently at the registration section. In this case, it is advisable to change (or reduce) the aligning amount.

However, if the aligning amount is reduced too much, this could cause the leading edge void to vary adversely. So, when adjusting the aligning amount, try to choose the appropriate amount while checking the leading edge void at the same time.

January 2000 © TOSHIBA TEC 1 - 53 FC-22 ADJUSTMENT