(d) Installing the carriage drive wires to the wire pulleys

Winding the wire to the wire pulleys:

1.Fit the 3-mm ball terminal in the center of the wire into the hole in the wire pulley. The wire should be positioned so that the part of the wire with a hook on its crimped side be on the upper side.

Ball terminal

Wire pulley

2.Wind the wires onto the wire pulleys on the front and rear. The number of turns to be wound are as follows (see the illustrations below):

·One turn on the inside of the boss.

·Six turns on the outside of the boss.

After winding the wires on the pulleys, hold the wires with wire holder jigs to prevent them from unwinding.

[Rear side]

 

[Front side]

Ball terminal

1 turn

Pulley (front)

 

 

 

 

 

Boss

 

 

1 turn

 

Pulley

Hook

 

 

6 turns

(rear)

Ball terminal

 

 

 

 

 

6 turns

Hook

Boss

(Front)

Hook

Wire pulley

Wires

Ball terminals

(Rear)

Wire holder jig

Wire pulley

FC-22 ADJUSTMENT

1 - 78

January 2000 © TOSHIBA TEC

Page 96
Image 96
Toshiba FC-22 manual Installing the carriage drive wires to the wire pulleys