4.1.2Paper feeding jam

E11 Paper misfeed from the ADU

Is any paper remaining in the paper feed area inside the ADU unit?

YES

Remove the paper.

 

NO

Is the connector J103 on the LGC board disconnected?

Is the harness between the LGC board and the ADU drawer connector open-circuited?

YES

Reconnect the connector. Replace the harness.

 

NO

1. Replace the LGC board.

2. Replace the ADU unit.

E12

Paper misfeed from the bypass

Is any paper set in the bypass tray?

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

YES

Does the paper remain within the specified paper weight and stack height ?

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

YES

Is there any foreign matter such as scrap of paper in the paper

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

transport path from the bypass feed section up to the registration

 

 

 

 

 

 

 

 

rollers?

 

 

NO

 

NO

 

 

 

 

 

 

YES

 

 

 

 

 

 

 

 

 

 

 

 

 

Eliminate the foreign matter.

 

 

 

 

 

 

 

 

NO

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Check if the bypass pick-up roller, bypass feed roller or separa-

 

 

 

 

 

 

 

 

tion pad is not deteriorated. Replace them if necessary.

 

 

 

 

 

 

 

 

 

 

 

Adjust the paper weight and stack height to follow the specification.

Does the bypass paper sensor work? Does the actuator return normally?

NO

YES

 

1.Use the test mode to confirm that the bypass paper sensor is working nor- mally.

2.Reconnect the bypass paper sensor connector.

Repair the actuator if it is displaced.

January 2000 © TOSHIBA TEC

4 - 3

FC-22 TROUBLESHOOTING

Page 129
Image 129
Toshiba FC-22 manual Paper feeding jam E11 Paper misfeed from the ADU, E12 Paper misfeed from the bypass