Toshiba FC-22 manual Automatic Adjustment of the Auto-Toner Circuit, 100% AA3

1. 4 Automatic Adjustment of the Auto-Toner Circuit

With this copier, the filling and removing of developer material is automatically performed by opera- tion from the control panel. In addition, the auto-toner sensor is automatically adjusted successively after the automatic filling of developer material.

<Operation procedure>

Note: At the time of unpacking, if developer material is not filled, the steps (3) and (4) below do not need

to be performed.

(1)Remove the toner cartridges.

(2)While pressing [0] and [5] simultaneously, turn the power ON. The following appears on the display:

[0] [5]

n

[POWER]

100% AA3

TEST MODE

(3)Input a code with digital keys and press the [START] key.nThe developer material is removed.

Code 390 : All developer materials are removed (developer materials Y, M, C and K). 391 : All color developer materials are removed (developer materials Y, M and C).

392 : Only developer material K is removed.

(4)After all developer materials are removed, press the [INTERRUPT] key.

Time required for removing All developer materials	: Approx.10 min.
Color developer materials only	: Approx. 6 min.
Developer material K only	: Approx. 3 min.

(5)Open the front cover, install the developer cartridge(s) and then close the cover.

*When installing or uninstalling the developer cartridge(s), it is necessary to open and close the front cover.

(6)Input a code with digital keys and press the [START] key.

Code 200 :	All developer materials	221 : Color developer materials only
204 :	Developer material K only

(Code) n [START] n

100% 200 A3

TEST MODE

FC-22 ADJUSTMENT 1 - 46 January 2000 © TOSHIBA TEC