NEC NP901W user manual  Part Names of the Projector, Rear

1. Introduction

Part Names of the Projector

Front/Top

Zoom Lever

(→ page 26)

Focus Ring

(→ page 26)

Remote Sensor

(→ page 9)

Ventilation (inlet) / Filter

(→ page 122)

Adjustable Tilt Foot Lever

(→ page 27)

Adjustable Tilt Foot (→ page 27)

Controls

(→ page 6)

Ventilation (inlet) / Filter (→ page 122)

Built-in Security Slot ( )* Security bar

Lens

Lens Cap

*This security slot supports the MicroSaver® Security System.

Rear
Remote Sensor
(→ page 9)			SELECT
U
SB(
LAN)
USB
S-
VIDEOIN			LAN
	AUDIOIN
			COMPMOPNUETNETR1/IN
VIDEOIN	L/MONO
			CO
	AUDIO IN	R		AUDIOIN
USB Wireless LAN unit			MO		PC		AUDIOIN
			NITOR	OUT
					CO
	L/MONO		OUT	AUDIO	COMPMOPNUETNETR2/		HDMIIN
		R				IN
The model without the USB						CONTROL
wireless LAN unit has a dummy					ACIN
cover here.

Speaker (5W monaural)

Ventilation (outlet)

Heated air is exhausted from here.

Terminal Panel

(→ page 7)

Main Power Switch

When you plug the supplied power cable into an active wall outlet and turn on the Main Power switch, the POW- ER indicator turns orange and the projector is in standby mode.

(→ page 22)

AC Input

Connect the supplied power cable’s three-pin plug here, and plug the other end into an active wall outlet.

(→ page 21)

NOTE:

The USB Wireless LAN Unit emits weak radio waves when the projector is in standby* mode or turned on.

If you use the projector with the USB Wireless LAN Unit in the area where the use of wireless LAN equipment is prohibited, re- move the USB Wireless LAN Unit from the projector. (→ page 143)

*To stop emitting radio waves from the USB Wireless LAN Unit during standby mode, select [POWER-SAVING] from [STANDBY MODE].