NEC P, N 1093092 manual Installation Wall-Mountingthe Base, Mounting the Base on the Wall

Installation

Wall-Mounting the Base

Wall-Mounting the Base

Mounting the Base on the Wall

To mount the base on the wall (Figure 5: Mounting the Base on the Wall):

1.Run the base line cord in the wide wire channel as shown, but do not plug it into the base.

2.Run the AC adaptor cord in the narrow wire channel as shown, but do not plug it into the base.

3.Using suitable fasteners, attach the wall-mount bracket to the wall in the desired location.

-To make the base easier to remove later on, consider not tightening the fasteners all the way.

4.Snap the base onto the wall-mount bracket.

-Make sure the mounting ears fit all the way into their slots and the mounting tabs snap into place.

5.Connect the base line cord and AC adaptor cord to the base.

1

Mounting ear

Mounting tab

Wall

Line cord in wide channel

AC adaptor cord in narrow channel

(Optional) Line out to DSX Keyset

Figure 5: Mounting the Base on the Wall

To remove the base from the wall:

-If you did not tighten the fasteners, you can slide the base off the wall before going to the next step.

1.Unplug the line cord and AC adaptor cord from the base.

2.Press the mounting tabs to release the wall-mount bracket from the base.

DSX Cordless Lite II Telephone User Guide Chapter 1: Installation ◆ 7