Advanced Routing, Dhcp Client | NetComm N300 instruction

NetComm Liberty Series - 3G Wireless N300 Router

Advanced Routing

This page allows you to configure static and dynamic routing rules for your 3G Router.

Advanced Routing – Static

Static Routing allows computers that are connected to your 3G Router to communicate with computers on another LAN segment which are connected to it via another router. To set a rule, you need to specify the following:

•Destination

•Sub Netmask

•Gateway

•Interface

Advanced Routing – Dynamic

Dynamic Routing uses the RIP protocol to allow the 3G Router to adapt to changes in the network. RIP enables the device to determine the best route for each packet based on the “hop count” or number of hops between Source and Destination. To enable Dynamic Routing, select Enable from the dropbox and click Apply.

DHCP Client

This page allows you to view the current DHCP client of your 3G Router.

YML18WN	3G18Wn User Guide
www.netcomm.com.au	1

Image 21

NetComm N300 manual Dhcp Client, Advanced Routing Static, Advanced Routing Dynamic

Contents

3G Wireless N300 Router Important Safety Instructions PrefaceSave Our Environment Table of Contents Introduction Package Contents Your 3G18Wn 3G Wireless N300 RouterKey Features Introduction Placement Placement of your 3G18Wn Router PlacementAvoid obstacles and interference Cordless Phones Choose the Quietest Channel for your Wireless Network Product Layout Wireless Computer System Requirements Connecting and Configuring your RouterProduct Layout Network and System Requirements Plug in the power Connecting your 3G RouterModem Requirements Connect the USB 3G Modem Configuring your Router and setting up your computer Default Settings Setting up your 3G Router Mac OSXFor 3G connections 3G Internet Settings 3G Connection StatusFor Non-3G Connections Advanced Features Advanced Features Login ProcedureStatus APN 3G Internet Settings‘OFF’ PIN Address field with the MAC address of your computer Pptp LAN Dhcp Client Advanced RoutingAdvanced Routing Static Advanced Routing Dynamic Wireless Settings Basic Wireless Settings Advanced Security Mode SecurityWEP WPA/WPA2 WPA-PSK/WPA2PSK WPS Station ListWPS Ssid WPS PIN Firewall MAC/IP/Port Filtering Firewall DMZ Port Forwarding System Security Content Filtering Administration Management AdministrationUpload Firmware Ddns Setting Manager StatisticsSystem Log Troubleshooting Why my wireless client can not access the Internet? TroubleshootingWhy does my wireless connection keep dropping? Cannot establish a wireless connection? How do I reset my 3G18Wn to its factory default settings? Do not remember my encryption key. What should I do?What can I do if my Ethernet cable does not work properly? Establishing Your Wireless Connection Windows XP service pack Establishing Your Wireless Connection Mac OSX NetComm Liberty Series 3G Wireless N300 Router Windows Vista How To configure Wireless Security How To Configure Wireless Security Appendix Product Warranty Customer InformationGNU General Public License Limitations of Warranty Product Warranty Technical Support