NETGEAR DM602 manual ADSL Through a Modular RJ-11 Wall Jack, ADSL Through Other Wall Jacks

Reference Manual for the Model DM602 ADSL Modem

ADSL Through a Modular RJ-11 Wall Jack.

Note: The wall jack attached to the ADSL port of the modem must provide the ADSL signal on the inner pair of wires (pins 2 and 3 of the 4-pin jack). If this is not the case, a swapper (not included) is necessary to move the connection to the inner pair.

To install the Model DM602 modem directly to the wall jack without installing a telephone:

1.Connect the provided telephone cable to the wall jack.

2.Connect the other end of the telephone cable to the ADSL port on the modem.

To install both the Model DM602 modem and a telephone:

1.Plug the “LINE” connection from the included microfilter into the wall jack.

2.Connect the “DSL” jack of the microfilter to the ADSL port of your modem using the telephone cable provided.

3.Connect the “PHONE” side of the microfilter to your telephone, using your existing telephone cable.

ADSL Through Other Wall Jacks

1.Plug the “LINE” connection from the included microfilter into the wall jack.

2.Connect the “DSL” jack of the microfilter to the ADSL port of your modem using the telephone cable provided.

3.Connect the “PHONE” side of the microfilter to your telephone, using your existing telephone cable.

If you have additional telephones, you will need to purchase additional microfilters and connect them between the telephones and the wall jack. A microfilter is required for each telephone on the line.

Note: Microfilters are required to isolate your ADSL signal from your telephone signal. If microfilters are not used, or if they are connected backward, you may notice a “ticking” noise on your telephone, and the performance of your ADSL line may be affected.

2-6 Setting Up the Hardware