Network Instruments WAN Probe Kit Updating the WAN and 10/100 Drivers, Found New Hardware, Reconnect the power supply, 10.Close the computer cover and replace and tighten any screws

Make sure that the contacts of the network cards are correctly aligned with the PCI bus slots on the motherboard. Push the network cards down vertically until they are properly seated in the bus slots.

10/100 Ethernet NIC

WAN Interface

9.Tighten the locking screws on the fixing brackets until the cards are firmly connected to the computer cover (or to the attachment provided for expansion cards).

10.Close the computer cover and replace and tighten any screws.11.Reconnect the power supply, following the safety instructions.

12.Turn the system on. The new hardware will be recognized differently depending on whether you are running Windows 2000 or Windows XP. Refer to the appropriate section that follows to complete the driver installation.

Updating the WAN and 10/100 Drivers

After you have installed the cards and turned on the computer, both Windows 2000 and Windows XP will attempt to recognize and install drivers to match the new hardware. Make sure that you have installed the Network Instruments Probe software; you must supply a directory that the Network Instruments install program creates to the Found New Hardware wizard.

Installing the Interface Cards and Drivers 11