Digital T1/E1 TAP Kit
| MONITOR | LINK 1 | MONITOR MONITOR | LINK 2 MONITOR |
| ||
| TX |
| RX TX |
| RX |
| |
| IN |
| OUT | IN | OUT | : | |
| MONITOR LINK 1 | MONITOR MONITOR | LINK 2 | MONITOR | |||
| TX |
| RX TX |
| RX |
| |
| IN | OUT | IN | OUT |
| ||
Two (2) T1/E1 WAN | Two (2) T1/E1 Dual Link TAPs | Two (2) | |||||
Interface Cards & Cables | |||||||
|
|
|
|
|
|
T1/E1 Cables
Serial T1/E1 TAP Kit
(V.35 Version shown; others look slightly different)
B | DTE |
POWER
MODE
A B
DCE
ACTIVE OUTPUT
One (1) Serial T1 WAN
Interface Card & CableOne (1) Serial T1/E1 TAP One Serial Splitter
Cable
Hardware and Software Requirements
Make sure that the system on which you plan to install the Probe Kit meets these requirements before you begin installing the kit.
Hardware Requirements
The PC must meet or exceed these specifications:
•To guarantee T1/E1 or DS3/E3
•512MB RAM
•20 GB hard disk space
•2 available PCI slots
Software Requirements
The WAN Probe must be installed on Windows 2000 or Windows XP. Only the latest versions of Expert Observer and Observer Suite consoles are guaranteed to connect to the WAN Probe.
Getting Started | 3 |