calibration similar to one conducted during production process. To perform the accuracy correction, select corr from the CAL menu.
Perform correction according to required measurement parameters by pressing Action button, see table below:
Active mode of | Correction |
| |
measurement | Condition | ||
parameter | |||
(Std) |
| ||
|
| ||
|
|
| |
D, dE | Distance | Install unit at 1 meter1 | |
from a flat target2 | |||
C |
| Put unit on a level plane | |
Azimuth | and aim it to the North | ||
|
| direction 3 | |
E, dE | Elevation | Put unit on the | |
horizontal level | |||
|
| ||
|
|
|
1 – Accuracy of correction will depend on accuracy of installation against the target. It must be exactly as specified. The numbers shown on the display reflect the correction.
2 – Target should not have
3 – The unit shall be well levelled with deviation from 0 not more than ±0.75 degrees. Horizontal direction shall be to
15
