Nikon Scene auto

Display	Cause/Solution	A
	• There are no images available for a slide
All images are hidden.	show, etc.	–
	• There are no images that can be displayed on
	the image selection screen for deletion.
This image cannot be	The image is protected.	E50
deleted.	Disable protection.
	• When the scene mode is Scene auto	43
	selector, you can take an image even if the
Raise the flash.	flash is lowered but the flash will not fire.
	• When the scene mode is Night portrait or	42, 46
	Backlighting with HDR set to Off, you must
	raise the flash to take an image.
	The camera could not receive the
	communication signal from the smart device.
No access.	Select Connect to smart device in the Wi-Fi	98, E58
	options menu, and wirelessly connect the
	camera and smart device again.
	The camera failed to establish the connection
	while receiving the communication signals from
Could not connect.	the smart device. Select a different channel for	98, E58
	Channel in Options in the Wi-Fi options menu
	and establish the wireless connection again.
	A cable was connected to the camera while the
	camera and smart device were wirelessly		Reference
Wi-Fi connection	connected, the battery level became low, or the	98, E58
terminated.	connection was aborted due to poor
	connectivity. Check the status of the camera and
	establish the wireless connection again.		Section
	Turn the camera off and then on again. If the
	A lens error occurred.
Lens error	error persists, contact your retailer or Nikon-	26
	authorized service representative.
Communications	An error occurred while communicating with
	the printer.	E14
error	Turn the camera off and reconnect the USB
	cable.
	An error occurred in the camera’s internal circuitry.
	Turn the camera off, remove and reinsert the
System error	battery, and turn the camera on. If the error	26
	persists, contact your retailer or Nikon-
	authorized service representative.

E79