Nikon ED 600MM instruction manual Lens hoods HK-29-1 and HK-29-2, Filter holder, Lens care

Lens hoods HK-29-1 and HK-29-2

Two-part lens hoods (HK-29-1 for attachment to the front of the lens and HK-29-2 J for attachment to the front of HK-29-1) are provided.

Using the HK-29-1:First, loosen the lens hood screw on the HK-29-1, slip HK-29-1 onto the front of the lens, then tighten the screw.

Attaching the HK-29-2:Loosen the lens hood screw on the HK-29-2, slip HK-29-2 onto the front of the HK-29-1, then tighten the screw.

En Storing the lens hoods: First, reverse the HK-29-2, and slip it back onto the HK-29-1. Then reverse the HK-29-1 with the HK-29-2 attached, and slide both back onto the front of the lens.

Filter holder (Fig. 4, 5)

G Always use a filter. The slip-in filter holder is provided with a 52mm screw-in Nikon NC filter. Use an L37C filter to cut ultraviolet rays and a slip-in circular polarizing filter C-PL1L to cut unwanted reflections from non-metallic surface such as glass or water.

1Press down on the filter holder knob, and turn counterclockwise until the white F line on the knob is at a right angle to the axis of the lens.

2Pull the holder out and screw in the filter into the holder.

•The filter holder can be attached either facing lens or camera side without having any effect on your pictures.

SDedicated gelatin filter holder (supplied accessories) (Fig. 6)

A 55mm slip-in gelatin filter holder is supplied with the lens to match your shooting purposes.

IT

Ck

Ch

Lens care

•Clean the lens surface with a blower brush. To remove dirt and smudges, use a soft, clean cotton cloth or lens tissue moistened with ethanol (alcohol) or lens cleaner. Wipe in a circular motion from center to outer edge, taking care not to leave traces or touch other parts.

•Never use thinner or benzene to clean the lens as this might damage the lens, result in a fire, or cause health problems.

•When storing the lens in the lens case, attach both front and rear caps. •When the lens will not be used for a long time, store it in a cool, dry place to

prevent mold. Also store the lens away from direct sunlight or chemicals such as camphor or naphthalene.

•Do not get water on the lens or drop it in water as this will cause it to rust and malfunction.

•Reinforced plastic is used for some parts of the lens. To avoid damage, never leave the lens in an excessively hot place.

16