Nikon F80D Confirm indications in the viewfinder while lightly, Aperture are shown in 1/2 steps

Confirmi IndicaI i tionsi inin Viewfinderi i and Releasel Shutter

7	Confirm that / (in-focus
	indicator) appears in the
	viewfinder, then slowly, fully
	depress the shutter release
	button. Camera automatically
	tracks subject that has been
	moving (page 88).
7.1	Confirm indications in the viewfinder while lightly
	pressing the shutter release button. (Shutter speed
	and aperture are shown in 1/2 steps.)

•When the subject is dark or the shutter speed is slower than 1/60 sec., use the built-in Speedlight to avoid picture blur (page 30).

•If any warning indications appear in the LCD panel or viewfinder, see page 101.

7.Confirm that focus indicator / appears and slowly

2 depress the shutter release button.

•After shutter is released, the film automatically advances to the next frame and the next shot can be taken.

28

	Check points		OPERATION
	When you reach the end of the film roll, the film starts to rewind automatically.
	Focus, shutter speed and aperture can be confirmed in the viewfinder. If any
	other warning indications appear, see page 101.
	For mid-roll rewind, see page 36.		BASIC
	For self-timer operation, see page 68.
	When the camera back is opened before the film is completely rewound
	(before E blinks), warning indication (blinking o––and frame counter) appears
	in the LCD panel and viewfinder. Refer to page 103 for troubleshooting.
7.3		Film starts to rewind automatically when film reaches
		the end of the roll.

•o––, o– and then o appear in the LCD panel and viewfinder during film rewind and the frame counter counts down until rewind is complete.

•Pictures taken on frames beyond the indicated number of the exposures for the film roll may be discarded in the process of developing.

c 1: Film rewind can be changed not to start automatically when the end of a film roll is reached (page 71).

c 13: High-speed film rewind is normally executed. This film rewind can be changed to quiet film rewind (page 74).

7.4	Confirm that film is completely rewound, then
	remove film cartridge.

•Film is completely rewound when the frame counter shows blinking “E” in the LCD panel and viewfinder. (E appears without blinking when the exposure meter is off.) Make sure the film is completely rewound (E is blinking in the LCD panel and viewfinder), open the camera back away from sunlight and remove the film cartridge by tilting it to one side.

29