Menu/Features of Custom Setting
•Creating Custom Setting
1Set the exposure mode/Custom Setting select dial to · and select a menu number by rotating the Main- Command Dial.
•19 menus (1 to 19) are available with the F80S and 18 menus (1 to 18) are available with the F80/F80D.
2 Select the desired option number by rotating the Sub- Command Dial.
•When the desired option number is displayed in the LCD panel, ç appears in the LCD panel. Rotate the exposure mode/Custom Setting select dial to set desired exposure mode and picture can be taken with desired settings.
•The shutter cannot be released when the exposure mode/Custom Setting select dial is set to ·. Set the dial to the desired exposure mode before shooting.
•Cancelling Custom Setting
Set the exposure mode/Custom Setting select dial to
·and perform
•All the Custom Settings are cancelled and reset to their initial factory settings.
•Each Custom Setting can be cancelled and reset to initial setting by selecting the number of “initial setting” (e.g. 0 with Custom Setting menu number 1) at step 2 above.
70
•Menu number and Custom Setting options
*Refer also to the Custom Setting Menu table at the end of this instruction manual.
1. Automatic film rewind at the end of film roll (page 29)
Options: 0: Activated (initial setting) 1: Disabled
At initial setting, film rewind is automatically started when the end of the film roll is reached. However, the camera can be set not to rewind film at the end of the film roll but instead film rewind is started by pressing the two film rewind buttons „ for more than 1 sec.
2. Reset to DX film speed setting for new film (page 36)
Options: 0: Activated (initial setting) 1: Disabled
At initial setting, film speed automatically sets to s when a new film roll is loaded even after manually setting film speed to other than s. However, the film speed setting can be changed to remain the same.
3. Bracketing order (page 62)
Options: 0: Metered value, under, over (initial setting) 1: Under, metered value, over
Bracketing is normally performed in the order of the initial setting (page 62). However, this Bracketing order can be changed to be performed from negative compensation to positive compensation.
4. On-Demand Grid Lines superimposition display (page 5)
Options: 0: Not displayed (initial setting) 1: Displayed
At initial setting,
Custom Setting
71
