Troubleshooting

En If the camera cannot establish a strong connection to the PD-10 or if printing suddenly stops, check the following items.

Problem

Possible cause/Solution

The POWER lamp on the PD-10 does not light.

• Use fully-powered batteries.

 

• Check that the PD-10 is connected to the printer.

Unable to successfully set up the Profile Information on the

• Check that the printer is on and ready to print.

camera and PD-10./The camera cannot establish a strong

 

connection to the PD-10 (overall).

 

The camera cannot establish a strong connection to the

The wireless signal may be affected by something nearby. Move the camera and print-

PD-10./The connection is interrupted.

er closer together.

There is a problem with the wireless connection./The con-

The wireless signal may be affected by something nearby. Move the camera and print-

nection is interrupted.

er closer together. Perform a Reset, and then set up the Profile Information on the

 

camera again (c6).

Unable to successfully set up the Profile Information on the

Perform Steps 3 and 4 in “Setting Profile Information on the Camera” (c6 - 7) in rap-

camera and PD-10. (BUSY lamp blinks rapidly in orange.)

id succession. In Step 4, the START button must be pressed for two seconds.

POWE

START BUSY

Resetting

If the Reset button is pressed for about one second while the PD-10 is on and connect- ed to the printer, all of the Profile Information set in the PD-10 will be deleted.

Press the Reset button with a small, thin object.

10

Page 16
Image 16
Nikon PD-10 Troubleshooting, Resetting, Problem Possible cause/Solution, Check that the printer is on and ready to print