TIPS ON SPEEDLIGHT CARE
1.After using the speedlight and camera under- water, rinse them both as soon as possible in fresh running water with the sync and sensor cords attached. When the speedlightlcamera assembly gets dirty, rinse it thoroughly in fresh water. Immediately after using it in salt water, rinse it thoroughly in fresh water to remove any residue. Otherwise, corrosion may occur in minute places like small holes or the junctions of parts. To prevent this, soak the speedlightl camera assembly overnight in a basin of fresh water, then rinse it vigorously in running water while paying special attention to the joint @, arm @, bracketscrew @,buckles ®, andsimilarparts where it is very difficult to remove mud or salt. Finally, dry the speedlight/camera assembly with a soft
When the unit is completely dry, check the
All moving parts should be lubricated to prevent corrosion and facilitate attachment. Apply lubri- cant sparingly and be sure to wipe off any excess. When the speedlight will not be used for some time, store it in a cool , dry, clean place with the batteries and battery chamber cap removed .
2.Never submerge the speedlight in water with the sync or sensor socket cover removed, or get the sync or sensor cord plugs wet. Always make sure the sync cord and sensor cord plugs are securely attached before entering the water.
3.Never pick up or suspend the speedlight by the sync or sensor cords.
4.If an
5.Do not allow the speedlight to be exposed to direct sunlight for long periods . And never place the speedlight in an area where the temperature is or may rise to 60°C (140° F) such as in a closed car or car trunk during w'armweather.
6.
If you experience difficulty of an electrical nature with the unit, never attempt to disassemble or service it yourself. Instead, take the unit to an authorized Nikon dealer or service center.
7.As much as possible, avoid removing the battery chamber cap near salty wind or splashing water because either may damage the unit'selectrical circuitry. If the battery chamber cap must be
removed in one of these situations, for instance, to exchange batteries, use a vinyl bag to prevent water or salt from entering the unit.
8.When not using the speedlight, remove batteries to prevent damage from battery leakage. Leaking batteries may also cause dangerous combustible gases to be trapped inside the battery chamber. If the battery chamber becomes corroded by leakage, take the unit to an authorized Nikon dealer or service center.
9.To remove dirt or fingerprints, wipe with a soft, dry or silicon,treated cloth. Never use thinner, benzine, or alcohol because they may damage plastic parts. To clean the
10.If this speedlight is frequently used underwater
(especially in salt water or dirty water), take it to an authorized Nikon dealer or service center for inspection on a regular basis .
11 . If the speedlight is dropped or bumped against a hard surface, take it to an authorized Nikon dealer or service center for inspection even if there is no surface damage.
12. After using the speedlight, attach the
.............I ".I .
7
