5 Replace the C -type

battery cartridge in the battery chamber.

Be sure the speedlight power switch

®is in the " OFF" position, then align the groove on the battery car- tridge with the notch on the inside of the compartment and slide the battery cartridge into the chamber.

8 Lock the buckle lockl

• release latches.

Push the buckle lock/release latches over the edges of the buckles to lock them .

6. Replace the battery chamber cap.

While holding the buckles away from the battery chamber cap, align the battery chamber cap index @ with the index on the speed- light case and replace the battery chamber cap.

Check the O·ring: Before replacing the battery chamber cap, examine its O-ring for dust and scratches and be sure it is properly seated and lubricated .

9 Loosen the joint

• knob ® .

To loosen the joint knob, turn it counterclockwise while holding the joint plate ®.

7, lock the buckles.

Push the battery chamber cap against the speedlight case so it is fully seated, hook the silver buckle catches onto the pins on the speed- light case, and pull the buckles in- ward and upward until they lock into position.

When locking the buckles, be sure the silver buckle catches are hooked onto the pins on the speed/ight case.

10 Properly position the

• joint plate.

Turn the joint knob so the flat sides of the joint plate are parallel with the flat edges of the joint.

9

Page 9
Image 9
Nikon SB-102 Lock the buckle lockl Release latches, Replace the battery chamber cap, Loosen the joint Knob