A-12 / ENGLISH
REMOVING THE BRUSHES
1Turn the Master Key Switch (J) OFF.
2Loosen the Black Knob (A) on top of the idler assembly and remove the idler assembly. Slide the brush out of the brush deck housing.
3To reinstall, slide the brush into the housing, lift slightly, push and turn until it seats. NOTE: Make sure Slots (B) in end of Brush line up with and seat firmly on Lugs (C) on the Drive End Assembly.
|
| |
|
| |
| "# $ | |
|
| |
|
| # |
|
| %&' |
|
| !( |
! | ||
REMOVING THE VACUUM SHOES
1Turn the Master Key Switch (J) OFF.
2Loosen the Black Knob (D) on the back of the scrub deck. Lift the
| Bar (E) up and remove. Slide the vac shoe out of the shoe support |
|
3 | weldment (F). Procedure is the same for both vac shoes. |
|
Reinstallation is reverse of removal. |
CHARGING THE BATTERIES | ||
Charge the batteries each time the machine is used, or whenever the |
| |
Battery Condition Meter (K) is showing a yellow, red or flashing red |
| |
indicator light(s). | ||
To Charge the Batteries... |
| |
1 | Depress the Battery Disconnect (13). | |
2 | Open the Battery Compartment Cover (16) to provide proper | |
| ventilation. | |
3 | Push the connector from the charger into the Battery Connector (22). | |
4 | Follow the instructions on the battery charger. |
|
5 Check the fluid level in all battery cells after charging the batteries. Add distilled water, if necessary, to bring the fluid level up to the bottom of the filler tubes.
WARNING !
Do not fill the batteries before charging.
Only charge batteries in a
Do not smoke while servicing the batteries.
CAUTION !
To avoid damage to floor surfaces, always wipe water and acid from the top of the batteries after charging.
CHECKING THE BATTERY ELECTROLYTE LEVEL
Check the electrolyte level of the batteries at least once a week.
After charging the batteries, remove the vent caps and check the electrolyte level in each battery cell. Use distilled water to fill the batteries to the bottom of the filler tube.
Do not
CAUTION !
Acid can spill onto the floor if the batteries are overfilled.
Tighten the vent caps. If there is acid on the batteries, wash the tops of the batteries with a solution of baking soda and water (2 tablespoons of baking soda to 1 quart of water).
