Nilfisk-ALTO 107400337 C Important safety instructions, Symbols used to mark instructions

NEPTUNE 5 FA

Symbols used to mark instructions

Before using the h i g h - p r e s s u r e cleaner, be sure to also read the en- closed operating in- structions and keep

them within reach at all times.

Safety instruc- tions in these op- erating instruc- tions which must be observed to prevent risks to

persons are marked with this danger symbol.

This symbol is used to mark safety in- structions that must be observed to pre- vent damage to the machine and its per-

formance.

This indicates tips and instruc- tions to simplify work and to en-

sure safe operation.

Operations marked with this symbol should only be carried out by Nilfisk- A LT O S e r v i c e Technicians.

1 Important safety instructions

	regulations.	with a suitable 3-phase plug with
	Besides the operating instruc-	ground, by a qualified electrician.
		Before use, check that the high-
	tions and the binding accident	pressure cleaner is safe and in
For your own safety	prevention regulations valid in the	proper condition.
	country of use, observe recog-
The appliance must	nized regulations for safety and	Regularly check whether the
	proper use.	power cord is damaged or shows
• only be used by persons,		signs of ageing.
who have been instructed	Do not use any unsafe work
in its correct usage and ex-	techniques.	Use the high-pressure cleaner
plicitly commisioned with the		only when the power cord is in
task of operating it.
	Do not tie the trigger handle	a safe condition. (risk of electric
• only be operated under su-
	open.	shock using damaged cord!).
pervision.
• not be used by children.	Transport	Check the rated voltage of the
• not be used by mentally or
		high-pressure cleaner before
physically disabled persons
	Transport of the high-pressure	connecting it to the mains power
Warning	cleaner is easy on its large	supply. Ensure that the voltage
	wheels.	shown on the rating plate cor-
• Ensure that any exhaust		responds to the voltage of the
emissions are not in the vi-	For safe transport in and on ve-	power supply.
cinity of air intakes.	hicles we recommend preventing
• This machine shall only be		We strongly recommend that the
	the equipment from sliding and
used with cleaning chemicals	tilting. Secure it with tie-downs	power supply to the high pres-
supplied or recommended	and apply the parking brake on	sure cleaner be connected via a
by Nilfi sk-ALTO. The use of	the castor wheel.	residual current circuit breaker.
other cleaning chemicals		This device stops the supply of
may adversely affect the	For transport at temperatures	electricity if the leakage current
safety of the machine.	around or below freezing 0°C	to the ground exceeds 30 mA for
• Risk of explosion – Do not	(32°F), anti-freeze should be	30 ms or it has an ground tester
use the cleaner to spray with	drawn into the pump beforehand	circuit.
fl ammable liquids.	(see chapter 6).	Please observe the regulations
General
	Before starting the cleaner	and provisions applicable in your
Use of the high-pressure cleaner		area. Before putting the high-
	If your 3-phase cleaner was sup-	pressure cleaner into service,
is subject to the applicable local	plied without a plug, have it fi tted	carry out a visual check of all the
2		1) Options / model variants

Original instructions