Nilfisk-ALTO 107400337 C Before starting the cleaner, Operating elements, Transport and assembly

				NEPTUNE 5 FA
2.2 Operating elements	See fold-out page at front of these		13	Display (Temperature or
	operating instructions.			Codes)
			14	Temperature control
	1	Spray lance	15	Low fuel indicator
	2	Spray lance storage	16	Low Nilfisk-ALTO AntiStone
	3	Control panel		(Anti-Scale) indicator
	4	Crank handle for	17	Service interval due/expired
		High pressure hose reel	18	Pump oil low
		(Neptune ..X)1)	19	Detergent metering knob
		Cord reel (Neptune ..X2)1)	20	Pressure gauge
	5	Fuel level gauge	21	Power ON
	6	Tank fi ller for fuel	22	Castor with parking brake
	7	Receptacle for service	23	Water supply connection
		crane and lifting ring1)	24	Tank fi ller for anti-freeze
	8	Top cover release	25	Tank fi ller for Nilfi sk-ALTO
	9	Service door release		Anti-Scale
	10	Crank handle for	26	Canister for detergent B1)
		High pressure hose reel	27	High pressure hose reel
		(Neptune ..X2)1)		(Neptune ..X)1)
	11	High pressure hose connec-	28	Power cord reel
		tion for machines without		(Neptune ..X2)1)
		hose reel	29	Tank fi ller for detergent A
	12	Main switch ON/OFF - cold	30	Grip for top cover
		water/hot water

3 Before starting the cleaner

3.1Transport and assembly

1.The safest way to lift the ma- chine is to use a fork-lift truck The arrows in the illustration indicate the best places to po- sition the fork.

2.It is also possible to lift the ma-

3.2Set the brake

chine by hand from the pallet. Due to the weight this work should be done by at least three persons.

CAUTION!

Do not hold the plastic tank to lift the machine as it could become detached from the frame.

The best places to hold the ma- chine are

–on the handle

–on the frame between the front wheels and the guide rollers.

Every fuel-burning appliance, such as pressure washers, depends upon a proper mix of fuel and air (by weight) for proper combustion. Therefore some adjustment of the

air supply to the burner may be nec- essary to take account of altitude and the resulting air pressure.This is true whether your fuel is ‘Natural gas’, Propane or Diesel.

Your Nilfisk-ALTO hot water pres- sure washer was thoroughly tested and adjusted for optimum perform- ance before it left our factory. The factory is located at approximately 120m (390 ft) above sea level, and the combustion settings are optimal for that elevation.

If your location is higher than 1200m (3900 ft) above sea level, your burner may require re-ad- justment for proper performance and best fuel economy. Contact your Dealer or Nilfisk-ALTO for assistance.

1.Before using the cleaner for the first time, check it careful- ly for any faults or damage.

2.Run the machine only when it is in perfect working condi- tion.

3.Set the brake.

4.The slope on which the high pressure cleaner is placed must not exceed more than 100 in any direction.

1) Options / model variants 5

Original instructions