OPERATING INSTRUCTIONS
1,2
6
3
| 4 | 5 |
|
| |
C0470 |
| FIGURE 8 |
NOTE
Before starting, perform the
PRE-START CHECKLIST - See Figure 8
1.Check controls for proper operation
2.Make sure all controls are in the “Off” position
3.Be sure accelerator / directional control pedal is in the neutral position.
4.Check all Dust flaps for damage or wear.
5.Check Main Broom and Side Broom for proper broom pattern.
6.Ensure that the hopper latch is properly engaged.
TO START MACHINE
1.Release the Wheel Lock.
2.Turn key to “On” position.
POST START CHECKLIST
1.Check the Battery Condition Meter for sufficient battery charge. This must be done with the machine running.
TO TRANSPORT MACHINE
1.Be sure the Main Broom and Side Broom Controls are in the “UP” or “OFF” position with all other controls in the “OFF” position.
2.Push forward on the directional control pedal to place the machine in motion.
3.Vary your foot pressure on the directional control pedal to obtain desired travel speed.
4.To stop, allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return to neutral when foot pressure is released).
TO BEGIN SWEEPING
1.Lower the Side Brooms by Moving the Side Broom Lift Lever to the “Down” Position.
2.Turn on the Side Brooms by setting the side brooms switch to the “On” Position.
3.Turn on the Dust control system by setting the Dust Control Switch to the “On” position.
4.Move the broom lift lever to the “Sweep” or “Float” position.
5.Vary your foot pressure on the directional control pedal to obtain desired travel speed.
6.To stop, allow directional control pedal to return to neutral (centered) position. (Pedal will automatically return to neutral when foot pressure is released).
| 114 RS Operator’s Manual |
