OPERATING INSTRUCTIONS
| SIDE AISLES |
| MAIN AISLE |
P4134/0001 | SIDE AISLES |
P4134 | FIGURE 9 |
HELPFUL HINTS FOR SWEEPING - See Figure 9
Here are some suggestions to keep in mind while sweeping.
1.Plan your sweeping in advance. Try to arrange long runs with minimum stopping and starting.
2.Pick up large debris before sweeping with the Machine.
3.Use the sweeper to sweep debris from side aisles into the main aisle.
4.After the Sweeper has made a sweeping run, turn off the dust control switch and use the filter shaker, Push and hold the shaker switch for approximately 15 seconds
5.Allow a few inches of overlap of sweep paths. This will eliminate leaving dirty patches.
6.Sweep in straight paths and do not bump posts or scrape the sides of the machine.
7.Periodically turn the sweeping broom end for end to prevent the bristles from “setting” in one direction.
8.Do not turn steering wheel too sharply when machine is in motion. The machine is very responsive to movement of the steering wheel - so avoid sudden turns.
9.As the Hopper becomes full, the sweeper will start to leave debris on the floor. When this occurs stop sweeping and empty the hopper.
TO EMPTY THE HOPPER
1.Place the Main Broom Lever in the “Off” position, raise Side Brooms, and proceed to the disposal site for emptying the Hopper.
2.Stop the Sweeper, Turn off the dust control switch and shake the filter for 15 seconds.
3.Place all controls in the “Off ” position and engage the wheel Lock.
4.Proceed to the rear of the Sweeper and unlock the Hopper latch.
5.Grasp the Hopper Handle and remove the hopper.
6.Dump the Hopper. Get Help if needed.
7.Position the Hopper and install it making sure that the Hopper goes in squarely.
8.Lock the Hopper Latch.
9.Resume Sweeping or perform the Post Operation Checklist if finished Sweeping.
TO STOP THE SWEEPING OPERATION
When the sweeping has been completed follow these instructions.
NOTE
After stopping, perform these post operation checks.
POST OPERATION CHECKLIST
1.Before turning off key switch, Check Battery Condition Meter.
2.Stop Machine and turn key switch to “Off” and Engage Wheel Lock.
3.Check all flaps for wear, damage, and adjustment.
4.Empty Hopper
5.Check Main Broom and Side Broom for wear or damage.
6.Charge Batteries if determined to be necessary in step 1 above.
114 RS Operator’s Manual |
|
